The positioning angle of expansion device
The positioning angle of expansion device installation must be based on the measured temperature, calculate the expansion amount to adjust the gap between the two positioning angle distance and positioning angle according to the bridge deck height will be welded to the steel reinforcement embedded, so the strict control of the gap distance. For the expansion joint spacing, hold a rather small tendency not big, is absolutely intolerable.
The positioning angle near the concrete in the construction of vibrator is difficult, dead and parts intensive steel, should strengthen the manual vibrating.
the setting of continuous seam
According to the design of continuous joint width and span bridge beam (plate) the difference between the length of the design set, 30m combination of T continuous beam width 6cm; various width of 4cm continuous slab; wedge adjustment curve on curve bridge deck set in cap and wedge parts of continuous suture set by two slits and each slot width not less than 4cm, usually the design width of 2cm is small.
Continuous deck joints, deformation pseudomorphism width and depth must be standardized, uniform, seam width and depth are advised by 0。5 - 2。5cm one set, this is convenient for construction。
pouring of concrete in Anchorage Zone
Bridge Lane concrete pavement should be the same as the expansion device of anchorage zone of concrete at the same time pouring, construction joints stay at the site and the entire deck is not allowed.