(1) the expansion joint is installed with the slotting method, which is the first to carry out the construction of the bridge deck pavement, and then to install the expansion joints. The asphalt concrete pavement layer is used to control the smoothness and elevation of the concrete and the expansion joint.
(2) the expansion joint should be installed on the temperature of the annual average temperature. When the installation temperature and annual average temperature difference affects the joints during normal use, the manufacturer should be under the guidance of engineers, remove the clamp, Jack adjustable telescopic gap, to meet the requirements, and then install the fixture, to preparation of the installation.
(3) expansion joint after installation must be flat, vertical and horizontal slope meets the design requirements, and on both sides of the asphalt concrete pavement smooth connection.
(4) it is strictly prohibited to connect the joints of the expansion joint directly with the embedded steel bar in the concrete.
(5) before installation, the expansion joint should be properly stored, no deformation and pollution。
(6) the construction of the air compressor is strictly prohibited, generators and other power equipment directly on the road, all the machinery must take effective measures to prevent oil spills pollution of the road.
(7) after the installation, it is necessary to ensure that the asphalt concrete around the expansion joint is clean, free of pollution and no damage.
(8) the installation of the expansion joint can not affect the road flow, need to do well in advance, can not be a safety accident. Set the bridge width to have a certain width of the car.