Welcome to Hengshui Jianfeng Engineering Rubber co., LTD.,!

The positioning angle of expansion device

author: Jianfeng Engineering from: 原创 date: 2017/10/1 18:00:00 hit: 12210 ℃
Tips: The positioning angle of expansion deviceThe positioning angle of expansion device installation must...

The positioning angle of expansion device

The positioning angle of expansion device installation must be based on the measured temperature, calculate the expansion amount to adjust the gap between the two positioning angle distance and positioning angle according to the bridge deck height will be welded to the steel reinforcement embedded, so the strict control of the gap distance. For the expansion joint spacing, hold a rather small tendency not big, is absolutely intolerable.

The positioning angle near the concrete in the construction of vibrator is difficult, dead and parts intensive steel, should strengthen the manual vibrating。

the setting of continuous seam

According to the design of continuous joint width and span bridge beam (plate) the difference between the length of the design set, 30m combination of T continuous beam width 6cm; various width of 4cm continuous slab; wedge adjustment curve on curve bridge deck set in cap and wedge parts of continuous suture set by two slits and each slot width not less than 4cm, usually the design width of 2cm is small。

Continuous deck joints, deformation pseudomorphism width and depth must be standardized, uniform, seam width and depth are advised by 0。5 - 2。5cm one set, this is convenient for construction。

pouring of concrete in Anchorage Zone

Bridge Lane concrete pavement should be the same as the expansion device of anchorage zone of concrete at the same time pouring, construction joints stay at the site and the entire deck is not allowed.

General situation of bridge telescopic device

Classification and scope of application

Extension of the company's production of bridge expansion joint device and a rubber strip type device, suitable for expansion is equal to or less than 50mm below the highway bridge engineering: type BF with plate rubber expansion device, which is suitable for the expansion of highway bridge engineering is less than 200mm, not suitable for highway; ZT-SF comb plate telescopic device is made of steel plate comb after a cross shaped telescopic gap, at the other end of the stainless steel plate, the above expansion amount of up to 40mm, for large, medium span bridge; ZT-GQF-C type (Z type, F type, M type, O type) bridge expansion device for expansion is less than 80mm and Z;T-GQF-MZL type expansion device is a modular bridge expansion device is composed of shaped steel and the linkage mechanism, it is suitable for the expansion of the 80-1200mm bridge expansion device; ZT-XF series is composed of parallel special-shaped steel in bridge joint direction and oblique displacement and supporting box. It is also suitable for expansion in bridge engineering 80-1200mm.


contact us

TEL: +8613132415777
FAX: 86-318-8538660
Email: eric@bojinsc.com
URL: http://www.bojinsc.com
ADD: Hengshui City, Hebei Province, China

Copyright © 2016 Hengshui Jianfeng Engineering Rubber co., LTD., All Rights Reserved.

北京赛车pk10投注 北京赛车pk10投注 pk10开奖结果 北京赛车pk10投注 北京赛车pk10投注 北京赛车pk10投注 北京赛车pk10投注 pk10开奖记录 北京赛车pk10投注 北京赛车pk10投注